Este é o Kit que será utilizado na Workshop de Introdução à "Physical Computing" com Arduino, pela Digitópia, Casa da Música. Este Kit inclui o Arduino Mega com o ATmega1280.

This is the starting Kit, to be used in the "Introdução à Physical Computing com Arduino" workshop by Digitópia, Casa da Música. This kit does include the Arduino Mega with the ATmega1280.

O Kit é composto por/This Kit is made of:

1 Book: Arduino, Getting Started With
1 Arduino MEGA with ATmega1280

1 USB cable
1 Straight single line pinhead connectors 2,54 40x1
1 Breadboard, 840 tie points
1 Set of 70 breadboard jumper wires
5 10K Ohm Resistors 1/4W
5 2.2K Ohm Resistor 1/4 W
10 220 Ohm Resistors 1/4W
5 330K Ohm Resistors 1/4W
5 100nF capacitor polyester
5 10nF capacitor polyester
3 100uF electrolytic capacitor 25Vdc
1 4,7K Ohm Thermistor
1 70..100K Ohm LDR VT90N2
3 5mm RED LED
1 5mm GREEN LED
1 5mm YELLOW LED
1 10Kohm linear potentiometer, pcb terminals
2 BC547 Transistor in TO92 Package
1 Piezo buzzer
5 PCB Pushbutton, 12x12mm size
2 4N35 Optocoupler DIL-6 package
2 Tilt sensor
1 Diode 1n4007
1 MOS Irf540

Extras:

2 Piezo sensors, with 2M resistor and 5V1 zenner diode
1 RGB LED and respective resistors
1 SuperBright White LED
1 SuperBright Blue LED
1 Ping-Pong Ball
2 Small DC Motor, 3V to 6V
1 L293D Motor Driver
1 Plastic Propeller
1 Light Sensor