This is a KIT with all the parts to partecipate to an Arduino Workshop. This kit does not include the Arduino Diecimilia Board. You can find a huge list of tutorials at our wiki. For those who just want a good introduction to Physical Computing with the Arduino use the following tutorials from TodBot.

Introduction tutorial

• Arduino Spooky Projects 1
• Arduino Spooky Projects 2
• Arduino Spooky Projects 3
  
• Arduino Spooky Projects 4
  

Base Level is made of:
1 USB cable
1 Straight single line pinhead connectors 2,54 40x1
1 Breadboard, 840 tie points
1 Set of 70 breadboard jumper wires
5 10K Ohm Resistors 1/4W
5 2.2K Ohm Resistor 1/4 W
10 220 Ohm Resistors 1/4W
5 330K Ohm Resistors 1/4W
5 100nF capacitor polyester
5 10nF capacitor polyester
3 100uF electrolytic capacitor 25Vdc
1 4,7K Ohm Thermistor
1 70..100K Ohm LDR VT90N2
3 5mm RED LED
1 5mm GREEN LED
1 5mm YELLOW LED
1 10Kohm linear potentiometer, pcb terminals
2 BC547 Transistor in TO92 Package
1 Piezo buzzer
5 PCB Pushbutton, 12x12mm size
2 4N35 Optocoupler DIL-6 package
2 Tilt sensor
1 Diode 1n4007
1 MOS Irf540