Arduino ProtoShield Kit inmotion.pt - DIY tools for the creative mind

Arduino ProtoShield Kit without Breadboard	8.95EUR

Model: INM-0012

Description: Riding on the waves of the very popular Arduino USB board is this small prototyping shield. Originally spawned with collaboration between the folks at SFE and ITP @ NYU, the Protoshield mates with the Arduino USB board and gives the user a small soldering area, two general LEDs, access to a BlueSMiRF socket, a general pushbutton switch, and most important of all - the Arduino reset switch is brought to the top level.

This comes in kit form and must be soldered together by the end user. Please note - we do not ship assembly instructions! There are a few tutorials on assembly listed below. All soldering is through-hole (relatively easy) but always check your component orientation before soldering!

The kit is pictured with the bread-board option. We highly recommend this breadboard! The bread board can be purchased separately as a related item.

Kit Includes:

1 - Protoshield bare PCB
1 - 40pin break-away male header
3 - 6-pin female connector
2 - 8-pin female connector
1 - 4-pin female connector
2 - Bright 5mm LEDs
2 - 330 Ohm resistors
2 - Momentary push buttons
1 - 10k resistor
2 - 0.1uF Capacitors

Features:

All Arduino pins are brought to the top level
5V, GND, and Raw pins are exposed as well
BlueSMiRF socket for wireless communication between Arduinos
2 general use LEDs
1 general use button
Reset Button brought to top level

Documents:

This product was added to our catalog on Saturday 13 September, 2008.

Quantity:

Customers who bought this product also purchased

Non-Invasive Current Sensor - 30A	Arduino Wireless SD Shield (XBee Ready)	Photo Interrupter GP1A57HRJ00F
Box for Arduino	Pololu Basic SPDT Relay Carrier with 12VDC Relay (Partial Kit)	MaxSonar-UT Ultrasonic Transducer MB1100